What's new in v6.18:

 * MAN PTM immo off/on (tokens) More info
 * MAN FFR immo off/on (tokens)
 * MAN FFR reading VDF (Vehicle Data File) directly from ECU (tokens)
 * MAN PTM reading VDF (Vehicle Data File) directly from ECU (tokens)

 * MAN ZBR parameter: central lubrication (tokens)

 * MAN ZBR parameter: air sensors (tokens)

 * MAN ZBR parameter: AdBlue control in OBDU (tokens)

 * MB/KAMAZ CPC4 speed limit (tokens)

 * MB/KAMAZ CPC5 speed limit (tokens)
 * VCM3 EEPROM read/write via OBD/DC (License VCM2 DC)
 * DC2U-CPC5 cable support added

What's upgraded:

 * MB CPC new versions (45, 4B) are added

 * MB MCM2.1 new versions (0007C1, 0006BC) are added

 * MB ACM2.1 new versions (00022A, 00024F, 000E4F, 000E1D, 000E3E) are added

* fixed: DC2 FR/CPC connection fixed (was "bad cable ID" or "internal error")

* fixed: MR XC2287, XC2288 FLASH write fixed

* fixed: VCM3 FLASH write fixed

* fixed: CPC EEPROM write fixed (was "error 9.0")

* fixed: Ignition popup during connect to KAMAZ truck

* fixed: MR hardware version A8/A7 in BSL mode detection fixed
* fixed: PTM EEPROM read via JTAG (invalid data was returned)
* fixed: MB TCM unpairing fixed "error 0.0"

* fixed: VIN check is not so strict (now we show "< invalid >" only if it is totally unprintable)

* fixed: MR VeDoc in BSL mode fixed "Internal error"
* fixed: IVECO EDC7UC31 was not detected over OBD

* fixed: IVECO CALC fixes PIN read

* fixed: for unknown ECU versions we allow to read EEPROM too (before we allowed to read FLASH only)